7
WIFI SIGNAL BOOSTER
3W / 2.4Ghz
35
dBm
Technical Specifications
FAQ (Frequently Asked Questions)
Operating range:
2.4~2.5 GHz.
Operating mode:
Bi-directional, half-duplex, time division duplex senses RF, carrier from
transmitter and automatically switch receiving to transmitting mode.
Antenna connector type:
SMA female (hole inside) 50ohm.
Radio connector type:
RP-SMA female (pin inside) 50ohm.
Input power:
0~20dBm.
Transmit gain:
15-18dB.
Output power:
3000mW (35dBm).
Receiver gain:
≤12dB.
Noise figure:
≤3.5 dB typical.
Frequency response:
±1dB over operating range.
Supported voltages:
5V~16V/2A DC.
Operating temperature:
-20°C to +70°C.
Operating humidity:
Up to 75% relative humidity.
Material:
Cast aluminum.
Booster Weight:
46g.
Booster Size:
7.3x4x1cm.
For any other problems or questions, please contact your supplier, or with Sunhans directly:
1. My WiFi booster ´s light indicator, does not blink blue. It just shows the white light.
What ´s the problem?.
2. The white light is off, but the blue light is blinking.
3. The light indicator does not work. There is no light when I plug the power supply.
4. The signal is not strong enough or it barely increased.
Please, check the connection between the radio (RC, router, IP camera…) and the “To
Radio” connector of the WiFi booster. If the connection is right, maybe just the blue
LED has a problem. So check if the level of signal increased. If you do not have any
improvement in your signal strength, the blue LED does not blinks and the installation
was right, please, contact the supplier where you bough the product to file a warranty
claim.
Please, check the connections between the radio and the booster. Also between the
booster and the antenna. Check that the blue light is blinking. If it all looks correct,
relocate the booster in a higher place and orientate the antenna.
Please, check if your power supply operates between 5V to 16V 2A. If it does, contact
your supplier.
The white LED is possibly broken. But the booster is working properly.
