Sungrabber IN-GROUND, Инструкция по установке и эксплуатации

Страница: 4 / 12

4
WHAT’S NEEDED TO INSTALL YOUR SUNGRABBER TM ? (CONTINUED)
INSTALLING YOUR SUNGRABBER TM
The ideal location for your SunGrabber TM system is a south-facing
pitched roof closest to your pool equipment with enough space to
mount your panel(s). West-facing would be a second choice
followed by east with north being the least desirable. Be certain
that trees or other structures do not shade the location you select.
The effectiveness of your SunGrabber
TM system is dependent on
the amount of direct sunlight. Survey the roof to confirm a proper
fit.
A 3/4 to 1 1/2 horsepower pump will generally handle installations
up to 30 feet away from the pool equipment and one story high.
Large systems and remote installation may require a pump with
more horsepower. If your pool has a gas heater or heat pump,
plumb the solar system in between the filter and gas heater/heat
pump. You should see a reduction in your monthly energy bill!
You can install up to (12) 2’ wide solar panels either
horizontally (20’ panels) or vertically (10’ and 12’
panels).
When transporting panel(s) to the roof or rack and
while positioning panel(s) before mounting, be sure
they are not dragged over any sharp surfaces.
Each SunGrabber
TM
solar panel is water pressure
tested and drained at the factory so it is common for
some residual water to be present in your solar
panel upon delivery.
Additional parts required other than P/N 267 System Kit can be purchased at you local hardware store.
TOOLS REQUIRED
Cordless drill
1/8” drill bit
7/16” socket and driver
1/2” ratchet
Flathead and Phillips screwdriver
1/4” socket driver
Tape measure
Marking pencil
Hack saw or PVC pipe cutter
AVAILABLE SUNGRABBER
TM
ACCESSORIES
P/N 241-2 1 1/2” X 2” Panel Add-on Adapter Kit
P/N 250-1 High Wind Roof/Rack Mounting Kit (1 required per (2) 2’ panels
plus 1 additional per system)
P/N 261-2 Panel Add-on Kit
P/N 262 Panel Repair Kit
For more information on accessories, please contact your nearest SunGrabber
TM dealer or visit us on the web at www.sungrabber.com
Typical Horizontal Installation
Typical Vertical Installation
Rubber Cap
VRV
(for drainage)
1 1/2” Rubber Cap