background image

Care and Maintenance

Cleaning After Use

Clean and disinfect your tanning canopy after each use. Use a non-

abrasive  disinfectant  cleaner  (such  as  a  mixture  of  2oz  of  Lucasol™ 

disinfectant with 1 gallon of water) that does not contain ammonia or 
ammonia derivatives which may damage the plastic surfaces. Spray the 
canopy with disinfectant until thoroughly wet. Allow to remain wet for 
10 minutes and then let air dry. Wipe the canopy grill with a soft cloth 
slightly dampened with disinfectant, then let air dry.

For  heavily  soiled  areas  remove  the  soil  (lotions,  etc.)  using  Lucas® 

Spray and Wipe Tanning Bed Acrylic Cleaner. Apply solution with spray 
bottle to wet the area thoroughly. Allow to remain wet for 30 seconds 
and then wipe the surface dry. Then disinfect as described above.

Thorough Periodic Cleaning

The cooling fans draw air through the canopy and will cause a dust 

buildup on the lamps and reflectors. When a dust buildup is observed, 

it is necessary to thoroughly clean the inside of the canopy.

Remove the metal grill and lamps.

With a soft cloth, wipe the entire length of each lamp.

Clean the grill with a non-ammonia disinfectant cleaner.

Wipe the reflectors with a clean damp cloth.

Re-install the lamps and grill.

Use a vacuum to clear dust away from fan openings.

Mechanical Inspection

Inspect the unit’s mechanical integrity every 400-500 hours of use.

• 

Inspect the unit’s fasteners verifying that all are firmly in place. Pay 

particular attention to the stand screws.

• Inspect gas spring for signs of wear. Replace gas spring if it will not 

easily assist in lifting the canopy.

• Inspect the AC power cord and its connections.

Removing/Replacing Canopy Grill

The  metal  grill  in  the  canopy  is  secured  in  place  by  hinged  profiles 

which run the length of the unit, both front and back. Start at the end 
and simply 

1

 push the inside edge of the profile toward the aluminum 

frame until it releases its latching action and then 

lift. Continue to 

lift the profile across its entire length until it swings back freely. Repeat 
for the other profile. As you pry the hinged profile open the canopy grill 

should start to drop out on its own.

Replace the grill by putting it in place 

and  closing  the  hinged  profiles  by 

pushing them back into place until 
they snap tight.

PROFILE

GRILL

Replacing Lamps

To be assured of maximum tanning effectiveness, change lamps after 
approximately 500 hours of use. Tanning will continue after this time 

but at a slower rate. We recommend using the lamps specified below. 
Use of uncertified lamps is a violation of Federal regulations and may 

void your warranty.

Grasp a lamp at one end and at the middle, then turn the lamp a 
quarter turn. The lamp may then be gently removed from its holder.

To reinstall lamp, insert pins on the ends of the lamp into the slots on 
top of the lamp holder and turn the lamp a quarter turn.

The following lamps have been certified for use in this equipment:

SunFire® 

POWER WINDOW

® Model SFPW71-T12-100W/P Bi-Pin

SunFire® Model SF71-T12-100W/P Bi-Pin

5

Hour Counter

The timer contains an hour counter so you know when to change 
lamps. With the sunbed turned off (the timer displays “0”), simply hold 
the stop button for three seconds. The display will show two pairs of 
numbers which indicate the hours of service, then return to “0”. (ex-
ample: Display shows 08 then 54. This equals 854 hours.) To reset the 
hours, unplug the bed. Press and hold the green timer button as you 
plug the bed in. Release the button after a few seconds.

Содержание 12R









Отзывы:

Похожие инструкции для 12R