Sunfab Hydraulics AB, Box 1094, SE-824 12 Hudiksvall, Sweden. Tel: +46 650-367 00, Fax: +46 650-367 27, E-mail: [email protected] Web: www.sunfab.com
L
R
200/200 bar 220 + 116 = 336 Nm
350/350 bar 385 + 203 = 588 Nm
400/400 bar
441 + 232 = 673 Nm
7019EN1809 REV 1.0 1/8
PUMP SCPD 70/36 DIN BY-PASS
EN
INSTRUCTION MANUAL
THANK YOU FOR CHOOSING SUNFAB
You have chosen SCPD 70/36 DIN, a dual flow pump with differentiated
flow suitable for combination vehicles with high power take off ratio and high
output speeds. Compact design and easy installation makes SCPD 70/36
one of the mainstays for powerful, trouble free hydraulic systems
REMEMBER
A trouble-free hydraulic system is created using selected components and
correct installation. Consequently, follow the instructions in this manual,
which includes checking the power take off, tank design, hose dimensions,
installation and start up. Failure to carry out the manufacturer’s installation
conditions will invalidate the warranty.
INSTALLATION REQUIREMENTS
POWER TAKE-OFF
• Pump mounting: Spline shaft DIN 5462 / ISO 14.
Mounting flange ISO 7653-D.
• The power take off can be engine, flywheel or gearbox mounted
• The output speed of the power take off must not exceed the pump’s max
speed, relieved = 2550 rpm
• The permitted torque output on the power take off must be higher than the
pump shaft’s torque at maximum pressure
• The power take off’s direction of rotation must correspond with the selected
pump, which is supplied in left-hand (L) or righthand (R) designs
NOTE! The cover must not be turned to change the direction of rotation.
