3. Settings
3.8 Rear Camera
PARK
PAS TYPE : Selecting Type of parking guide line
- NOT USED : Not use Parking guide line
- PAS ON : Selecting Dynamic Parking guide line
- PAS OFF : Selecting fixed Parking guide line
PAS SETUP : Adjusting the position of the parking guide line (available in PARK SETUP->
V-POSITION, H-POSITION)
REAR TYPE : Choose rear camera recognition
* LAMP - Detecting the rear view camera via rear lamp (Installer must connect
“Rear-C” cable of the power cable to the rear lamp of the car.)
*CAN - Detecting the rear view camera by CAN signal (Installer must connect
“CAN” cable of the power cable to the “CAN” cable of the car.)
SAFE ENABLE : If your car is connected with CAN cable and it is in ”ON” state, you can
NOT watch DVD or A/V except original image or navigation while
driving. At that time the screen use only main and navigation(default :
OFF)
PDC TYPE : When PDC mode, Selecting screen ratio
* OEM CAM : The car has original camera and install external camera
* EXT. CAM : The car doesn’t have original camera and install external camera
* 15Y HARMAN : When original PDC is located in middle of the screen
(Dip switch #5,6,7-ON)
a. If you want to get to the FACTORY mode, set the gear as rear state and press “LEFT”
button 2 seconds long on the remote control or the keypad. (as shown left top)
FACTORY mode
–
Press
◀
button 2 seconds long on the remote control.
※
After installing rear camera : DIP S/W #7
must be put down (ON). Refer to page 9.
26
IMAGE
PARK
UTIL1
UTIL2
INFO
PAS TYPE
PAS SETUP
REAR TYPE
SAFE ENABLE
PDC TYPE
Menu of FACTORY
MENU to Return
SEL to Select/Save
Ca
rN
av
i-T
ec
h
