Specifications
Supported protocols
DMX data refresh rate
DMX input ports
DMX output ports
DMX connectors
Mounting
Power supply
Mains Fuse
Input power
Operating Temperature:
IP Rating
DMX512, RDM
44 Hz
1 or 3 isolated
5,8 or 10 isolated
XLR (5 pins, 3 pins) or RJ-45 (etherCON)
Rack
~100-250 VAC, 50/60 Hz
0.5 A
5 W
-0°С... +60°С
IP 20
General information
Splitter Pro is a single-channel DMX512 splitter and is an effective solution for controlling dynamic
lighting equipment. A feature of the splitter is the ability to transfer DMX512, RDM (ANSI E1.20)
protocols from one input to 5 or 10 outputs.
Splitter Duo Pro is a double-channel DMX512 splitter with 2 inputs and 8 outputs. Splitter Duo Pro can
work as two separate splitters 1-to-4, or as a single splitter with 1 input and 10 outputs
(similar to Splitter Pro).
Splitter Pro and Splitter Duo Pro can be supplied with XLR 5-pin, XLR 3-pin, or EtherCON connectors.
RDM support can be enabled and disabled by a stick switch on the front panel.
Each input connector has a through-output connector to pass DMX512 signal to other devices in a chain.
The device is designed in a housing for installation in a 19-inch rack and can be used at positive
temperatures indoors.
Safe operation
In installation, operation, preventive maintenance and
repairs of the device, the requirements of the safety rules
must be followed.
To ensure safe and reliable operation of the devices, please
observe the following requirements:
Use the device only for its intended purpose
Do not use devices that shows signs of malfunctioning
Avoid strong physical impacts on the device
Protect devices and cables from contact with corrosive liquids
Whenever a fault is detected in the device, please contact the manufacturer.
Warning!
The device uses hazardous
voltage AC 100-250V
3
Splitter PRO
