Sundown Audio SAE-1000D, Руководство пользователя

Страница: 3 / 8

Double Sided Through Hole Epoxy PCB
Daisy-Chain Through Output RCA
Efficiency : 86% @ 4 ohm, at 100Hz
24dB/Oct Variable Crossover
Multi-Way Protection Circuitry
(Thermal/Over Current/Speaker Short/Speaker DC Protection)
Variable Subsonic Filter
Variable Bass Boost
Variable Low Pass Filter
Variable Phase Shift
Zero(0) Gauge Power Supply Connectors
Tested Voltage & THD : 14.4V & Less than 1% THD
Operating Voltage : DC 10V~16V
Digital Class-D Linkable Mono Block Amplifier
1 Ohm Stability
RCA Line Input and Master Output
24dB Octave Crossover Slope
Wired Remote Controller
Features
-3-
Specifications
Rated power output
-RMS power, 2 ohm linkable/dual mono ------
-RMS power, 1 ohm mono ------------------------
-RMS power, 2 ohm mono ------------------------
-RMS power, 4 ohm mono-------------------------
Signal to Noise Ratio -----------------------------------
Low pass frequency crossover ---------------------
Subsonic filter ----------------------------------------------
Bass boost @ 45Hz -------------------------------------
Phase shift control----------------------------------------
Frequency response--------------------------------------
T.H.D @ 4 ohm----------------------------------------------
Efficiency @ 4 ohm-----------------------------------------
Fuse rating---------------------------------------------------
Input Sensitivity -------------------------------------------
Dimensions---------------------------------------------------
1800W x 1CH
1000W x 1CH
600W x 1CH
300W x 1CH
>90dB
35Hz~300Hz
10Hz~60Hz
0~18dB
0~180 degree
10Hz~350Hz (+/- 1dB)
<0.1%
86%
25A x 3
200mV to 6V (+/- 5%)
260(W) x 51(H) x 294(L)mm
Power Connection
BATTERY
to REMOTE Turn-on
from HEAD UNIT
GROUND
To +12V DC
FUSE POWER SPEAKER
B+ REM GND
B A
+12V Power
Connect the +12V terminal of the amplifier to the + terminal of the
battery using a large gauge power wire (preferably 1/0 gauge). It is
critical to utilize an in-line fuse within 8 inches of the battery to
ensure safe operation of the amplifier. Make sure that the fuse is
not installed while you are connecting the + wire to the battery
terminal to avoid sparking and possible injury or damage.
GROUND
Disconnect the battery and connect the GND (ground) terminal to
the cars chassis. Keep this cable as short as possible (not longer
than 10 inches). Be certain that the chassis ground point is free of
rust, paint, and grime to ensure a solid electrical connection.
REMOTE
Connect the REM terminal to either the remote output lead from
the radio or another switched 12V supply such as the power
antenna wire.