2
1
、
Put the bottom of the
appliance
up.
2
、
Put the power cord through the center hole of the base
and cover the base onto the appliance.
3
1
、
Fix the base and
appliance
together with 4pcs
ST3
×
8
screw.
2
、
After fixing the screws, clip the power cord into the card
slot of the base.
Note: after base installation, check whether the base is
installed in place and whether the
appliance
shakes
before use!
Screws cannot be replaced arbitrarily!
2
、
Turn on the power switch first,
“
O
”
= OFF
，“—”
ON
；
1. Turn on the power switch, LED display “--”, the appliance is standby;
See picture 1.1
2. Press “
”as follows: ON (only Fan working), LED display
Environment temperature(default is
℉
after the power cut off);
OFF(Fan keep working for 30 seconds when shutdown the
appliance(after heating)
；
See picture 2.1
3. Press “
”, low heat(800W), high heat(1500W), FAN working, See
picture 3.1-3.2
4. Press “
”, SWING ON, SWING OFF, See picture 4.1
5. Press “
” to set timer, 1h
、
2h.....12h; See picture 5.1-5.4
6. Press “
”, Flame ON, Flame OFF. See picture 6.1
7. Press “
” to set temperature, Temperature range: 50-95
℉
. See
picture 7.1-7.2
7.1Press “
” over 3s, switch to
℃
, Temperature range: 10-35
℃
,
See picture 7.3-7.4.
Press
“
”
over 3s again,
switch to
℉
.
When the power supply is not cut off, keep the Temperature mode
the same.
7.2When use remote control to set temperature,
7.2.1Press “
” on remote control first,
7.2.2Then press “+” “-” to set temperature.
7.2.3The remote control can not switch the Temperature mode, only
can switch on the machine.
8. For example, Environment temperature is 25
℃
(77
℉
). See picture
8.1
Set temperature is equal to or lower than Environment temperature,
