Email: [email protected]
Facebook: #5sundayliving
7
Leakage protection plug operating instructions
Insert the plug in the socket, the
“
Reset
”
button is in pop-up position.
Press power switch, the indicator light stays off , which
indicates that there is no current output in plug.
Then press the
“
Reset
”
button, the indicator light turns on,
which indicates that there is current output in plug.
Now you should start the following experiment:
Press
“
Test
”
button, the power will be cut off immediately
because there is leakage current simulated in the plug. At the
same time,
“
Reset
”
button pops up and indicator light goes
off, which means that the leakage protection function of the
plug is effective.
Then press
“
Reset
”
button, the heater can be used normally
after the indicator light is on.
Please test as bellow steps every time before you start using
Caution:
1.It is strictly forbidden to dismantle the ALCI by your own.
2.It is strictly forbidden to spray water on the ALCI.
INSTALLATION INSTRUCTION
Wall MOUNTING INSTALLATION
Warning:
Check the wall to ensure there is no wiring, pipe wires etc in the area to be drilled.
Warning:
Do not plug in before wall mounting.
Note : The heater cannot be fixed on hollow wall. The heater must be mounted on firm wall.
（
1
）
（
2
）
Heater hook position
