Sundance Spas ALTAMAR 880, Руководство пользователя

Страница: 57 / 84

Page 51
880 SERIES
2. Rinse debris from all outer filter
(1) pleats using a garden hose
and high-pressure nozzle.
Repeat process until all filter
pleats are clean. Then rinse
debris from inside of filter (1). If
chemical cleaners are used,
follow manufacturers
instructions.
Lightly rise filter insert (2)
and place in clean location. *DO NOT use chemical cleaners or
high-pressure nozzle on insert (2) or it may be damaged, come
apart or allow impurities to re-enter the water, increasing the risk of
contracting a waterborne illness (e.g. an infection bacteria or virus)
and/or respiratory ailments.
3. Install filter insert (2) into outer pleated filter (1) by gently sliding
inward until a slight resistance is felt approximately 1/4” from bottom.
Lightly tap insert end with palm of hand to “snap” in place. Insert is
properly installed when end cap rests “flush” against outer filter end
cap.
4. Install Filter assembly back into spa by performing step 2 in reverse
order. Tighten filter nut so it just touches the filter face. DO NOT
OVERTIGHTEN!
5. Turn power to spa back on.
Replacement filter cartridges may be purchased from your Sundance
Spas dealer.
14.2 Draining And Refilling
About every 3 to 6 months, you will should replace the hot tub’s water.
The frequency depends on a number of variables including the amount
of use, attention paid to water quality maintenance, etc. You will know it
is time for a change when you cannot control sudsing and/or you can no
longer get the normal feel or sparkle to the water even though the key
water balance measurements are all within the proper parameters.
1
2
Top
1
2*