OWNER’S GUIDE
Page 8
instructions supplied with the cleaner.
•
Replace the window making sure that the seal around the frame is not damaged or
misplaced. Locate the channel at the top of the window over the top of the firebox
opening.
•
Refit the three spring-loaded screws and washers. Tighten sufficiently to seal to the
firebox.
•
Replace the case front.
To Clean the Fuel Bed or Rear Ceramic Wall
If, for any reason the fuel bed or rear wall require cleaning proceed as follows:-
•
Remove the front case and window as described above.
•
Carefully lift the fuel bed out of the firebox and place it on a piece of cardboard or
similar.
•
If necessary remove the rear ceramic wall from the bottom channel by pushing the
bottom edge of the wall upwards
and very slightly pulling the top
forward.
•
Carefully vacuum the upper and
lower surfaces of the fuel bed
(and wall if necessary) using a
soft brush attachment.
•
When refitting the fuel bed,
make sure that the front of the
coal locates behind the two
brackets which are behind the
bottom front panel of the
firebox. See figure 6.
Fig. 6 Fuel bed & rear wall positions
