Sunbeam’s Safety Precautions
1. Read carefully and save all the instructions
provided with an appliance.
2. Always turn the power off at the power
outlet before you insert or remove a plug.
Remove by grasping the plug - do not pull
on the cord.
3. Turn the power off and remove the plug
when the appliance is not in use and before
cleaning.
4. Do not use your appliance with an
extension cord unless this cord has
been checked and tested by a qualified
technician or service person.
5. Always use your appliance from a power
outlet of the voltage (A.C. only) marked on
the appliance.
6. This appliance is not intended for use by
young children or infirm persons unless
they have been adequately supervised by
a responsible adult to ensure that they can
use the appliance safely.
7. Young children should be supervised
to ensure that they do not play with the
appliance.
8. Do not use an appliance for any purpose
other than its intended use.
9. Do not place an appliance on or near a hot
gas flame, electric element or on a heated
oven. Do not place on top of any other
appliance.
10. Do not let the power cord of an appliance
hang over the edge of a table or bench top
or touch any hot surface.
11. For safety reasons and to avoid
maintenance by unskilled persons, some
appliances are ‘sealed’ using tamperproof
screws. Such appliances should always be
returned to the nearest Sunbeam Appointed
Service Centre for adjustment or repair if
required.
12. Do not operate any electrical appliance
with a damaged cord or after the appliance
has been dropped or damaged in any
manner. If damage is suspected, return
the appliance to the nearest Sunbeam
Appointed Service Centre for examination,
repair or adjustment.
13. For additional protection, Sunbeam
recommend the use of a residual current
device (RCD) with a tripping current not
exceeding 30mA in the electrical circuit
supplying power to your appliances.
14. Do not immerse the appliance in water or
any other liquid unless recommended.
SAFETY PRECAUTIONS FOR ALL ELECTRICAL APPLIANCES
Sunbeam are very safety conscious when designing and manufacturing consumer products,
but it is essential that the product user also exercises care when using an electrical appliance.
Listed below are precautions which are essential for the safe use of an electrical appliance:
3
Using your Back Massager
with Heat
1. Place the appliance on a suitable chair and
fasten using the elastic straps on the back
of the massager.
2. Ensure that the appliance is switched off
and then connect the adaptor output to the
input jack.
3. Plug the adaptor plug into a suitable power
outlet and switch on.
4. Do not use for more than 20 minutes at a
time.
5. If discomfort occurs, discontinue use
immediately.
MASSAgE OPTIONS
1. You can choose to massage one particular
area of your back or choose all areas
together.
2. Choose the’ neck’ option to massage the
neck and shoulders.
3. Choose the ‘upper’ option to massage the
upper back.
4. Choose the ‘lower’ option to massage the
lower back.
5. Choose the ‘heat’ option to apply soothing
heat to the lower back.
6. There are 2 massage settings. Choose
setting I for a relaxing massage and choose
setting II for a more invigorating massage
USINg ThE CAR AdAPTOR
1. Plug the cigarette lighter adaptor into the
car cigarette lighter socket.
2. The appliance is designed to operate on a
12V power supply. Do not connect to any
other power source.
3. Operate as above.
USINg ThE LUMbAR SUPPORT
1. The appliance has built in lumbar support
for added comfort.
2. To add support simply squeeze the air
pump until you have reached your desired
level. Keep fingers away from the air release
valve when pumping air.
3. To release the air support, depress the air
release valve at the bottom of the pump
6
Con
tro
l P
ane
l
Multi-function Hand
Controller
Zone 1
Neck &
Shoulders
Zone 2
Upper Back
Zone 3
Lower Back
heat
On/Off
Power
On/Off
Adaptor
Adaptor output
Car cigar
ette
lighter adaptor
5
You
r B
ack
M
ass
age
r w
ith
H
eat
Back massage
pad
Lumbar heat
Seat pad
Input jack
Air release
valve
Lumbar air
pump
4
VB4500_IB_Imposition.indd 3
7/05/2007 9:58:29 AM
