When using electrical appliances, basic safety precautions should always be followed to reduce the
risk of fire, electric shock, and injury to persons, including the following:
1. Read all instructions before using this appliance.
2. Use fan only for purposes described in the instruction manual.
3. To protect against electrical shock do not immerse unit, plug or cord in water or spray with
liquids and plug the appliance directly into a 120V AC electrical outlet.
4. Close supervision is necessary when any appliance is used by or near children.
5. Unplug from outlet when not in use, when moving fan from one location to another, before
putting on or taking off parts and before cleaning.
6. Avoid contact with moving parts.
7. Do not operate in the presence of explosive and/or flammable fumes.
8. To avoid fire hazard, NEVER place the cord under rugs or any parts near an open flame,
cooking or other heating appliance.
9. Do not operate any appliance with a damaged cord or plug after the appliance malfunctions, or
has been dropped/damaged in any manner.
10. The use of attachments not recommended or sold by the appliance manufacturer may cause
hazards.
11. Do not let the cord hang over the edge of a table, counter or come in contact with hot surfaces
or leave exposed to high traffic areas.
12. Do not use outdoors.
13. To disconnect, grip plug and pull from wall outlet. Never yank on cord.
14. Always use on a dry, level surface.
15. Do not operate fan until fully assembled with all parts properly in place.
16. This product is intended for household use ONLY and not for commercial or industrial
applications.
17. WARNING: To reduce the risk of electrical shock and injury to persons, do not use in window.
18. WARNING: To reduce the risk of fire or electric shock, DO NOT use this fan with any solid-state
speed control device.
ASSEMBLY INSTRUCTIONS
1. Slide the two feet included in the box into the fan housing until the locking
tabs fit securely into the tab locks. Refer to Figure 1.
2. Insert the plug end into the back of the fan as shown in Figure 2. Note the
orientation of the plug end to the opening in the back of the fan.
NOTE:
The feet have been designed so that you may wrap the cord around
them.
OPERATING INSTRUCTIONS
1. Set fan on a dry, level surface.
2. Please make sure the speed control is in the Off (
O
) position.
3. Plug cord into any standard 120 volt AC outlet.
4. The speed is adjustable by turning the speed control located on the back of the
Fan to the desired setting.
3: HIGH speed setting 2: MEDIUM speed setting
1: LOW speed setting
O
: OFF
FAN CLEANING
• Always unplug the fan before cleaning.
• Do not allow water to drip on or enter into fan housing.
• Be sure to use a soft cloth moistened with a mild soap solution.
• Do not use gasoline, paint thinner or benzene as a cleaner. You may also lightly run a vacuum
cleaner nozzle over the front grill to remove any dust or dirt.
Clean the fan grill and housing base with a soft, damp cloth. Please use caution around the motor
housing area. Do not allow the motor or other electrical components to be exposed to water.
FAN BLADE CLEANING
To clean the fan blade remove the front grill by unscrewing the six screws located around the
perimeter. DO NOT ATTEMPT TO REMOVE THE FAN BLADE. Clean with a soft, damp cloth. Ensure that
the front grill is securely fastened to the fan prior to beginning operation.
FAN STORAGE
When storing your fan in the off season, it is important to keep it in a safe dry location. It is
important to protect the fan head from dust. We strongly recommend using the original box from
purchase.
Owner’s Guide
SBF2012-CN
PLEASE READ AND SAVE THESE
IMPORTANT SAFETY INSTRUCTIONS
1 YEAR LIMITED WARRANTY
Sunbeam Products, Inc. doing business as Jarden Consumer Solutions or if in Canada, Sunbeam
Corporation (Canada) Limited doing business as Jarden Consumer Solutions (collectively “JCS”) warrants
that for a period of one year from the date of purchase, this product will be free from defects in material
and workmanship. JCS, at its option, will repair or replace this product or any component of the product
found to be defective during the warranty period. Replacement will be made with a new or
remanufactured product or component. If the product is no longer available, replacement may be made
with a similar product of equal or greater value. This is your exclusive warranty. Do NOT attempt to repair
or adjust any electrical or mechanical functions on this product. Doing so will void this warranty.
This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not
transferable. Keep the original sales receipt. Proof of purchase is required to obtain warranty
performance. JCS dealers, service centers, or retail stores selling JCS products do not have the right to
alter, modify or any way change the terms and conditions of this warranty.
This warranty does not cover normal wear of parts or damage resulting from any of the following:
negligent use or misuse of the product, use on improper voltage or current, use contrary to the operating
instructions, disassembly, repair or alteration by anyone other than JCS or an authorized JCS service
center. Further, the warranty does not cover: Acts of God, such as fire, flood, hurricanes and tornadoes.
What are the limits on JCS’s Liability?
JCS shall not be liable for any incidental or consequential damages caused by the breach of any express,
implied or statutory warranty or condition.
Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or
fitness for a particular purpose is limited in duration to the duration of the above warranty.
JCS disclaims all other warranties, conditions or representations, express, implied, statutory or otherwise.
JCS shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or
inability to use the product including incidental, special, consequential or similar damages or loss of
profits, or for any breach of contract, fundamental or otherwise, or for any claim brought against
purchaser by any other party.
Some provinces, states or jurisdictions do not allow the exclusion or limitation of incidental or
consequential damages or limitations on how long an implied warranty lasts, so the above limitations or
exclusion may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights that vary from province
to province, state to state or jurisdiction to jurisdiction.
How to Obtain Warranty Service
In the U.S.A.
If you have any questions regarding this warranty or would like to obtain warranty service, please call
1-888-264-9669 and a convenient service center address will be provided to you.
In Canada
If you have any questions regarding this warranty or would like to obtain warranty service, please call
1-888-264-9669 and a convenient service center address will be provided to you.
In the U.S.A., this warranty is offered by Sunbeam Products, Inc. doing business as Jarden Consumer
Solutions located in Boca Raton, Florida 33431. In Canada, this warranty is offered by Sunbeam
Corporation (Canada) Limited doing business as Jarden Consumer Solutions, located at 20 B Hereford
Street, Brampton, Ontario L6Y 0M1. If you have any other problem or claim in connection with this
product, please write our Consumer Service Department.
PLEASE DO NOT RETURN THIS
PRODUCT TO ANY OF THESE ADDRESSES OR TO THE PLACE OF PURCHASE.
If you have any questions regarding your product or would like to learn more about other
Sunbeam
®
products, please contact our Consumer Service Department at 1-888-264-9669 or visit
our website at www.sunbeam.ca.
Figure 2
Figure 1
Tab Lock
Locking Tab
© 2011 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved. Imported and distributed by Sunbeam Corporation
(Canada) Limited doing business as Jarden Consumer Solutions, 20 B Hereford Street, Brampton, Ontario L6Y 0M1.
Printed in the USA
THIS APPLIANCE HAS A POLARIZED PLUG (ONE BLADE IS WIDER THAN THE
OTHER). TO REDUCE THE RISK OF ELECTRIC SHOCK, THIS PLUG IS INTENDED
TO FIT IN A POLARIZED OUTLET ONLY ONE WAY. IF THE PLUG DOES NOT FIT
FULLY IN THE OUTLET, REVERSE THE PLUG. IF IT STILL DOES NOT FIT,
CONTACT A QUALIFIED ELECTRICIAN TO INSTALL THE PROPER OUTLET.
DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS SAFETY FEATURE
IN ANY WAY.
SBF2012-CN_11EFM1.indd 1
9/23/11 8:54 AM