Using the shot of steam
The shot of steam can be used whether dry
or steam ironing when the temperature dial
is set to any temperature above the two
dot (••) setting.
1. Ensure the tank is at least ¼ full of
water.
2. Select the desired temperature and
wait until the thermostat light goes
out.
3. Press the shot of steam button
several times with the iron on the
soleplate to prime the pump.
NOTE: If the tank has run dry, it may be
necessary to re-prime the pump after
filling the iron with water.
Using the spray mist
The spray mist can be used whether dry
or steam ironing to pre-dampen hard to
iron fabrics.
1. Ensure the tank is at least ¼ full of
water.
2. Press the spray button during ironing
to release a fine mist from the spray
nozzle.
Using your Sunbeam Pro Steam
Iron
(continued)
Using your Sunbeam Pro Steam Iron
The safety auto-off mechanism
automatically turns the iron off if you
forget.
The iron will automatically shut off if left
on the heel rest (vertical) for 15 minutes,
or in the ironing position (horizontal) for
30 seconds, without being moved.
The thermostat light on the handle will
flash and a warning beep will sound to
let you know that you have left the iron
unattended.
Power to the iron's heating element will
be cut.
Once the iron is moved the power will
reconnect. Allow the iron to heat until the
thermostat light goes out, and continue
ironing as normal.
The safety auto-off feature
(Model SR4315 only)
15 minutes
30 seconds
7
