Using your Cafe Series
®
Variable
Temperature Kettle
5
Before using your kettle.
It is recommended that you clean your kettle
before using it by filling the kettle with water
to the maximum level indicator, boiling the
water and discarding.
Important: Do not fill the kettle over the
maximum level, as water may spill out of the
spout when boiling.
1. To fill the kettle, remove it from the power
base and lift the lid, by pressing the button
at the top of the handle. Do not fill the
kettle below the 'min' indication.
2. Fill the kettle with the desired amount of
water. Always fill the kettle between the
minimum and maximum marks. Too little
water will result in the kettle switching off
before the water has boiled.
3. Push the lid closed firmly until it locks into
position.
4. Place the kettle onto the power base. Plug
the power cord into a 230-240 Volt AC
power outlet and switch the power on.
Note: If the kettle is not positioned on top of
the power base correctly the LCD panel will
show “--:---“.
Using your Cafe Series
®
Variable Temperature
Kettle
Tip: The Variable Temperature Kettle has five
optimum tea temperatures you can select
from: 80°C, 85°C, 90°C, 95°C and 100°C
(boil). Refer to the ‘Tea Brewing Styles and
Tips’ table on page 8 for the ideal water
temperature for your tea.
Note: The temperature settings are a guide
only and may vary depending on personal
preference.
1. Press the ‘TEMP’ button to select from five
pre-set temperatures: 80°C, 85°C, 90°C,
95°C and 100°C (boil). Your selected
water temperature will be displayed on the
LCD display for 3 seconds. Press ‘START/
CANCEL’ to initiate the heating cycle.
Note: If after 3 seconds nothing is pressed,
the LCD display will revert back to showing
the current water temperature.
Note: If the START/CANCEL button is pressed
without any temperatures being selected
beforehand, it will automatically default to
the last used setting. The START/CANCEL
button is originally preset to 100°C (boil).
2. When the heating cycle is initiated, the
LCD display will show the maximum
amount of time required to reach the
selected water temperature. The Time to
Boil feature shown on the LCD display will
count down and flash until the correct
time is calculated. Once the correct time
is calculated the Time to Boil recalibrates
to the correct time remaining and will no
longer flash.
5
Содержание KE9600
Страница 2: ......
