Sunbeam Intuitive EM8910, Инструкция пользователя

Страница: 23 / 52

21
• Swing the steam nozzle out to the side of
the machine and hold the jug under the
steam nozzle so that the nozzle opening is
completely immersed in the milk. Turn the
‘steam/hot water’ switch up to activate the
steam and commence frothing the milk.
See figure 27.
LCD: Indicates <<STEAM>>.
Tip: For instructions on how to froth milk
refer to the section ‘Easy steps for frothing
milk’.
Note:
The nozzle must not touch the bottom
of the jug to ensure that the steam release is
not obstructed.
• To stop the frothing process, turn the
‘steam/hot water’ switch down into the
off
•
position and then remove the jug.
See figure 28.
Important: There is risk of scalding by
splashing hot milk. Switch the steam off
before you remove the jug with the frothed
milk.
• Exit the steam mode by pressing the
steam pre-selection button, the indicator
light will turn off and the appliance is now
ready again for making coffee.
See figure 26.
Tip:
After steaming and the steam mode has
been deselected on the control panel, turn
the ‘steam/hot water’ switch up and allow hot
water to run out for a couple of seconds.
LCD: Indicates <<HOT WATER>>.
This will help the temperature of the espresso
machine return to coffee making temperature
and also prevent milk remains from drying
inside the steam nozzle and therefore blocking
the nozzle. Be sure to place a cup of some
kind under the steam nozzle when doing this.
Milk frothing (continued)