Sunbeam Dehumidifiers, Руководство пользователя

Страница: 6 / 9

6
OPERATION INSTRUCTIONS (cont’d)
WATER TANK:
Water will drain into the tank. When the tank is full and the dehumidi fi er stops operating, the
FULL indicator light will fl ash.
Do not remove the water tank while the dehumidi fi er is still working or has just stopped. This
might cause water to drip.
To empty the water tank, remove the tank as shown below, empty the water, and replace.
The dehumidi
fi er will restart when the water tank in back in the correct position.
•
•
•
•
Pull out the bucket.
Hold the two sides of the bucket and
with even strength, pull it out from
the dehumidifi er.
Pour out the water. 1.
2.
3.
1 2 3
CONTINUOUS DRAIN:
If a drain is located near where you position your dehumidi fi er, a hose can be connected for continuous
draining:
When using continuous draining, remove the rubber plug very carefully from the back drain hole
and store it in a safe place so it does not get lost.
Remove the water tank
fi rst, then attach the hose onto the connector located inside the dehumidi fi er.
The hose should go down smoothly without bends or kinks.
Place the end of the hose into a suitable drainage facility.
When the continuous drain feature is not being used, remove the drain hose from the connector and
plug the rubber plug back into the hole.
•
•
•
•
•
CARE AND CLEANING
IMPORTANT:
Be sure to unplug the dehumidi fi er before cleaning.
Do not use chemical agents to clean the dehumidi fi er, as they may cause damage.
Do not wash the dehumidi fi er directly under a tap or hose. The electrical components inside may be
damaged.
WATER TANK:
Wash the tank using warm water with a neutral detergent. Rinse and allow to dry. Replace tank
when dry.
•
•
•
•