3
Before using your kettle.
It is recommended that you clean your kettle
before use by filling the kettle with water up
to the maximum level indicator, boil and
discard.
Using your kettle.
1. To fill the kettle, remove it from the power
base and lift the lid. Alternatively, the
kettle may be filled through the pouring
spout.
2. Fill the kettle with the desired amount of
water. Always fill the kettle with at least
0.50L of water. Too little water will result
in the kettle switching off before the water
has boiled.
NOTE: Do not fill the kettle over the maximum
level, as water may spill out of the spout
when boiling.
3. Push the lid closed firmly until it locks into
position.
4. Place the kettle on the power base and
connect the plug into a 230-240v power
outlet. Turn the power ON.
5. Press the ON/OFF button downwards at the
base of the kettle. The kettle will switch off
automatically once the water has boiled.
NOTE: Ensure that the ON/OFF switch is clear
of obstructions and the lid is firmly closed.
The kettle will not turn off if the ON/OFF
switch is constrained or if the lid is left open.
Do not remove the kettle from the power base
while water is heating.
6. Lift the kettle from the power base and
pour the water.
NOTE: Use caution when pouring the water
from your kettle, as boiling water will scald.
7. The kettle may be stored on the power
base while not in use. The kettle will not
re-boil until the ON/OFF switch is pressed
downward.
NOTE: Ensure the power is turned off at the
power outlet when the kettle is not in use.
Should you accidentally allow the kettle to
operate without water, boil-dry protection will
automatically switch it off. If this occurs,
allow the kettle to cool before filling with
cold water and re-boiling.
Cord Storage Facility.
Excess cord can be stored by winding the
cord around the storage facility underneath
the power base.
Using your Alinea Kettle
Our 3-Way Safety System ensures that your
kettle will:
1. Automatically switch off after boiling.
For convenience, safety and energy
efficiency, your Sunbeam kettle will
automatically switch off after boiling.
2. Cut-out for boil-dry protection.
If the kettle is operated without water, it
will automatically cut-out, preventing any
damage to the element.
If this occurs, allow the kettle to cool
before filling with cold water and
re-boiling.
3. Shut-down in case of overheating.
In the event of overheating, the kettle will
automatically shut down to prevent further
damage. Should this occur, take your kettle
to a Sunbeam Service Centre or Appointed
Service Agent.
Sunbeam’s 3-Way Safety System
Содержание Alinea KE2700K
Страница 1: ...ALINEA COLLECTION KETTLE User Guide KE2700...
