SUNSWITCH INSTALLATION INSTRUCTIONS.
Step 1
Fix wall mounting bracket on a vertical wall protected from direct rain and sun.
Step 2
Locate
Roof Temperature Transmitter
adjacent to the solar collector.
It must receive similar sun to the solar collector but not be in contact with it.
Effective transmission range is up to 150 metres depending on surrounding
buildings. It is recommended that roof transmissions are confirmed before
fixing the transmitter permanently in place - just in case it needs to be moved
for best transmission.
Step 3
A
Pool ‘Cold’ Sensor
‘barb and grommet’ is provided. Drill a 13mm hole
and install it into a section of pipework prior to th
e solar pump, i.e. on the
intake side of the pump. Insert the 1.8m Pool Sensor cable into the well.
Step 4
Connect the Pool Sensor to the colour-matched connections on the controller.
Then slide unit into mounting bracket.
o
Step 5
Plug in solar circulation pump and switch ON. Set the Pool Temp to 30 C for
the initial start up.
NOTES:
[a] Joins in sensor cables must be soldered and waterproofed.
[b] Installation Option 2 requires the Time Clock to be set for daylight hours.
[c] SunSwitches are NOT designed to switch DC motors or Multi-speed
pumps as damage may occur to the electronics.
[d] For any repairs simply return to the place of purchase.
COLD WATER FROM POOL
WARM WATER
RETURNS TO
THE POOL
SOLAR COLLECTOR
SOLAR PUMP
SUNSWTICH CONTROLLER
POOL SENSOR
ROOF TEMPERATURE TRANSMITTER
POWER - 230V MIN.
ROOF-MOUNTED SOLAR POOL HEATING.
To simplify this diagram, the Collector area
(A)
is shown as a block of solar tubes. In your solar
system, these tubes could be part of a Flexible Strip system or a Rigid Panel system.
OFF
AUTO
TEMP
SET
MAN
ON
RCM 5209
240VAC/50Hz/10A
Sun
Switch
SOLAR
POOL HEATING
OPTION 1:
For pools with separate solar
supply and return pipework
- i.e. most new pools.
J
B
A
B
C
D
E
F
A
C
D
F
230V
E
Installation Video
