Leveling the DC Refrigerator
Remove the packaging support from the base of the appliance and replace
with the 2 leveling feet. Make sure the appliance is level. Use the leveling feet
at the front. If the appliance is not level, the doors and magnetic seal
alignments will be affected.
Cleaning before use
Wipe the inside of the appliance with a weak solution of bicarbonate soda.
Then rinse with warm water using a damp sponge or cloth. Wash the baskets
and shelves in warm soapy water and dry completely before replacing in the
fridge. The external parts of the fridge can be cleaned with wax polish.
Before plugging in YOU MUST notice below Safety Precautions:
SAFETY PRECAUTIONS
1)
Use an independent 12V or 24DC outlet with a capacity of no less
than 30A.
2)
This DC Refrigerator is only allowed to connect to a 12V or 24V DC
system. It is forbidden to connect it directly with an AC power supply.
3)
Do not immediately switch the DC Refrigerator on and off. It will
damage the compressor module. The normal time interval is ten (10)
minutes.
4)
Disconnect the plug from the outlet if the unit is to be left unused for
a long period of time. Check if the connection is okay before it is put
to use again.
5)
DO NOT store inflammable gases or liquids in your DC refrigerator
6)
The supplier is not responsible for any accidents or losses incurred
from the unit
Before switching on!
DO NOT SWITCH ON UNTIL TWO HOURS AFTER MOVING THE APPLIANCE
The coolant fluid needs time to settle
Please Note: The ice cube tray is for ice only and not for freezing food
Notices & Routine Maintenance
1)
Do not switch on the DC Refrigerator within 2 hours after
transportation. After the appliance has been placed it needs to be left
for 2 hours. This allows time for the coolant to settle.
2)
DO NOT
switch on the DC Refrigerator within ten (10) minutes after a
sudden power failure.
3)
The unit cannot be re-started until after a half an hour on the leveled
floor that it is moved to. The unit should be left to run for two (2) full
hours before food is put into it for storage.
4)
The temperature of the food in the unit should not exceed the
ambient temperature.
5)
Acids, alkaline, corrosive substances, volatile or inflammable materials
cannot be stored in case of damages to the cabinet of the unit.
6)
How to clean your SUN STAR unit:
a) Wipe down the interior walls and shelves with a soft cloth dipped in
a neutral detergent.
b) Exhaust the condensed water or wipe it off with a dry clean cloth.
c) The outside of the unit can be cleaned with a thin soda water or
alcohol and then wiped clean with a damp cloth.
7)
After the unit has been in use for half a year, wipe off the dust that has
been accumulated on the condenser, fan, and compressor.
8)
Leveling the DC Refrigerator. Make sure the appliance is level. Use the
rotating leveling feet at the front. If the appliance is not level, the door
and magnetic seal alignments will be affected and may cause your
appliance to work incorrectly.
9)
Locate the unit to be no less than fifteen (15) cm / six (6) inches from
the wall at the back and side.
10)
Do not attempt to repair your appliance yourself as it might endanger
you and others.
11)
Do not place your appliance near a heat source, e.g. cooker, boiler, or
radiator. Also avoid direct sunlight in outbuildings or sun lounges
Page 3
Page 8
Содержание ST-6RF
Страница 1: ...Copyright SunStar 2017 Model ST 6RF Owner s Manual...
Страница 2: ......
