Sun Oracle Netra SPARC T3-1B, Руководство по обслуживанию

Страница: 33 / 136

Detecting and Managing Faults 21
▼
Clear Faults (
clear_fault_action
Property)
Use the
clear_fault_action
property with the
set
command to manually clear
PSH-detected faults for a FRU.
If Oracle ILOM detects a FRU replacement, it will automatically clear the fault so that
you do not have to clear the fault manually. For PSH-diagnosed faults, if the
replacement of the FRU is detected by the system or the fault is manually cleared on
the host, the fault will also be cleared from Oracle ILOM. In such cases, you typically
do not have to clear the fault manually.
Note – This procedure clears the fault from the SP but not from the host. If the fault
persists in the host, clear it manually as described in “Clear PSH-Detected Faults” on
page 30 .
●
At the
->
prompt, use the
set
command with the
clear_fault_action=True
property.
Example:
Related Information
■
“Diagnostics Process” on page 7
■
“Access the SP (Oracle ILOM)” on page 15
■
“Display FRU Information (show Command)” on page 17
■
“Check for Faults (show faulty Command)” on page 18
■
“Check for Faults (fmadm faulty Command)” on page 20
■
“Service-Related Oracle ILOM Command Summary” on page 21
Service-Related Oracle ILOM Command Summary
The following table describes the Oracle ILOM shell commands most frequently used
when performing service-related tasks.
-> set /SYS/MB/CMP0/BOB0/CH0/D0 clear_fault_action=True
Are you sure you want to clear /SYS/MB/CMP0/BOB0/CH0/D0 (y/n)? y
Set ’clear_fault_action’ to ’true’