Sun Microsystems SunSwift SPARCserver 1000, Руководство по установке, Страница: 41 / 70

Powering the System On and Off 3-3
3
Figure 3-2 Key Switch in On Position
Note – If faulty parts are detected and configured out of the working system,
you and the system manager must decide whether to operate the system until
replacement parts arrive, or to halt operation. Also, if a faulty component
cannot be replaced in the field, the entire subassembly (like the system board)
must be replaced.
To run diagnostics again, or if the system hangs, press the reset switch behind
the front panel. To reach the reset switch:
1. Remove the key from the key switch.
2. Remove the plastic front panel. Push up on the latch at the bottom of the
panel and gently pull the bottom of the panel towards you.
The top of the front panel rests in a grooved channel on the system top front
edge. Once the bottom latch is released, the front panel lifts off (Figure 3-3).
3. Insert the back of a pencil or other narrow object into the small opening
in the center of the metal face plate and press the reset switch.
See Figure 3-4.
4. After the system is reset, replace the front plastic panel.
Rest the top of the front panel in the grooved channel on the top panel. Push
in on the lower portion of the front panel until it snaps back into place.
Standby
On
Diagnostics
Locked