Sun Microsystems Sun StorEdge T3, Инструкция по установке, эксплуатации и обслуживанию

Страница: 43 / 148

Chapter 2 Installation 2-5
6. Make sure that all the disk drives, the power and cooling units, the interconnect
cards, and the controller card (if present) are firmly seated in the unit.
7. Replace the front cover.
Caution –
You must replace the front panel for the disk tray to meet regulatory
emissions requirements.
2.3 Editing the Host Files
The JumpStart™ feature automatically downloads the assigned IP address to the
disk tray. To enable this feature, you must edit your host file before cabling the disk
tray. After you cable the disk tray and power on, the IP address is automatically
assigned. Before you begin, make sure you have the following:
■
MAC address. See
FIGURE 2-2
in the previous section for the MAC address
location. See Step 1 of the following procedure for the format of the MAC address.
■
IP address. For this information, contact the person who maintains your network.
■
Disk tray name. This is the user-assigned name of the disk tray you are installing.
Note –
If you are configuring a redundant controller configuration (partner group),
you need the MAC address that will be assigned only to the master-unit disk tray. In
a partner group, this is the disk tray that is located on the bottom. In Step 1, enter
the MAC address for the master unit. When you install the disk tray in the next
section, make sure that the master unit is placed on the bottom of the configuration.
Do not use the MAC address of the disk tray that you are placing on the top. In a
partner group, the disk tray that is placed on top is referred to as the alternate
master unit.
To set the network IP address for the disk tray:
1. On a host connected to the same subnet as the disk tray, edit the
/etc/ethers
file by adding the MAC address and disk tray name.
For example:
8:0:20:7d:93:7e
disk-tray-name