16
Sun StorEdge N8400 Filer Storage Upgrade Guide • September 2001
Finishing and Verifying the Installation
▼
To Create Logical Volumes
Note –
You must use the
vol
command to create logical volumes on your newly
installed storage before you try to create shares with the filer’s graphical user
interface (GUI).
●
Create one or more logical volumes with the
vol
command as described in the
Sun StorEdge T3 Disk Tray Administrator’s Guide, 806-1063.
If this step is unsuccessful, check all the connections and be sure that you performed
all the steps in configuring the arrays.
▼
To Verify the Installation
1. Start the Filer Administration Tool.
Refer to “To Start the Filer Administration Tool” in the Sun StorEdge N8400 and
N8600 Filer Administrator’s Guide.
2. Create a new share.
Refer to “To Add a New Share” in the Sun StorEdge N8400 and N8600 Filer
Administrator’s Guide.
3. Mount the newly created share from another host using both the NFS and CIFS
protocols.
If you can create and mount a share under both NFS and CIFS, your installation is
complete.
If you cannot create and mount a share, check all the connections and be sure that
you performed all the steps in configuring the arrays.
