Sun Microsystems StorageTek T10000, Руководство оператора

Страница: 96 / 120

Messages
94 T10000 Operator’s Guide • July 2008 Revision EA • 96174
Save Fails The new configuration cannot be saved
because the read-access memory (RAM)
might be defective. This message is associated with changing the
tape drive configuration, a task for
authorized service personnel only.
SavingDump
A dump is being saved to non-volatile
memory. None
Start Init Initialization has started. None
Trapped The IPL process is trapped in a loop. IPL the tape drive again. If the problem
persists, contact authorized service personnel.
Unloading A cartridge tape is unloading. None
UnWr
xxxx
,
where
xxxx
is an
FSC
The Unload switch was pressed during a
write operation. Some data remains
unwritten. To write the unwritten data, issue the
command:
ESCON Swap in VM/MVS
environment
Or, Press the
Unload
switch again; the
unwritten data is lost.
Write Prot The tape drive attempted to write to a write-
protected cartridge tape. Change the switch on the data cartridge tape
to enable writing.
Writing
The tape drive is writing data. None
TABLE D-1
Operator panel Display Messages (Continued)
Display Meaning Recommended Action