Sun Microsystems StorageTek SG-XPCIE1FC-QF8-Z, Руководство по установке

Страница: 21 / 68

11
C H A P T E R
2
Hardware Installation and Removal
This chapter describes how to install and remove the HBA. Refer to your system
installation or service manual for detailed instructions.
This chapter contains the following topics:
■
“Observing ESD and Handling Precautions” on page 11
■
“Installing the Hardware” on page 12
■
“Testing the Installation” on page 16
■
“Replacing the SFP+ Unit on the HBA” on page 23
■
“Removing the Hardware” on page 24
Observing ESD and Handling
Precautions
Caution –
Damage to the HBA can occur as the result of careless handling or
electrostatic discharge (ESD). Always handle the HBA with care to avoid damage to
electrostatic sensitive components.
To minimize the possibility of ESD-related damage, use both a workstation antistatic
mat and an ESD wrist strap. You can get an ESD wrist strap from any reputable
electronics store. Observe the following precautions to avoid ESD-related problems:
■
Leave the HBA in its antistatic bag until you are ready to install it in the system.
■
Always use a properly fitted and grounded wrist strap or other suitable ESD
protection
when handling the HBA and observe proper ESD grounding
techniques.
■
Hold the HBA by the edge of the PCB, not the connectors.