Sun Microsystems StorageTek 5320, Руководство по началу работы

Страница: 48 / 226

28 Sun StorageTek 5320 NAS Appliance and Gateway System Getting Started Guide • May 2006
Installing an Enclosure in a Cabinet
If you are installing expansion enclosures, install the first one in the first empty slot
at the bottom of the cabinet, and continue installing any additional expansion
enclosures from the bottom up, followed by the controller enclosure. For
information about order of enclosure installation, refer to
“Installing in the Cabinet”
on page 18 .
After installing each enclosure, you must connect its power cables and set the tray
ID as described in
"Setting the Tray ID" on page 49 .
▼
To Install an Enclosure in a Cabinet
1. Unsnap and remove the left and right end caps on the enclosure to permit access
to the screw mounting holes (
FIGURE 2-8
).
FIGURE 2-8
Removing the End Caps on the Enclosure