Sun Microsystems Ethernet PCI-X Adapter, Инструкция по установке и эксплуатации

Страница: 42 / 78

26 Sun 10-Gigabit Ethernet PCI-X Adapter Installation and User’s Guide • December 2005
●
To list all the parameters supported by the
ixge
driver, type
?
.
See
TABLE 3-1
through
TABLE 3-6
for parameter descriptions.
Note – By default, autonegotiation is set to
off
. This adapter operates only at full-
duplex.
Setting Parameters Using the
ixge.conf
File
Specify the driver parameter properties for each device by creating a
ixge.conf
file
in the
/platform/sun4u/kernel/drv
directory. Use a
ixge.conf
file when you
need to set a particular parameter for a device in the system. The parameters you
can set are the read and write parameters listed in “10-Gigabit Ethernet Driver
Parameter Values and Definitions” on page 20.
Note – Configuring the parameters by putting
ndd
commands in
rcX.d
scripts is
not supported.
The man pages for
prtconf
(1M) and
driver.conf
(4) include additional details.
The next procedure shows an example of setting parameters in a
ixge.conf
file.
●
To access any man page, type the
man
command plus the name of the man page.
For example, to access man pages for
prtconf(1M)
, type:
# ndd -get /dev/ixge \?
? (read only)
instance (read and write)
adv_asmpause_cap (read and write)
adv_pause_cap (read and write)
rx_intr_pkts (read and write)
rx_intr_time (read and write)
accept_jumbo (read and write)
laggr_multistream (read and write)#
% man prtconf