2
Sun FastEthernet PCI Adapter Product Note • August 1997
▼
To Replace the SunSwift PCI Adapter With a
Sun FastEthernet PCI Adapter in the Same PCI
Slot
Note –
Refer to your system’s installation or service manual for detailed
instructions for the following three steps.
1. Power off your system and open the system unit.
2. Replace the SunSwift PCI adapter with the Sun FastEthernet PCI adapter.
3. Close the system unit.
4. Power on the system, and when the OpenBoot PROM’s banner is displayed, press
the Stop-A keys to interrupt the boot process and to display the
ok
prompt.
5. At the
ok
prompt, use the
show-nets
command to list the system’s network
devices and to verify the Sun FastEthernet PCI adapter’s installation.
You will see the system’s network devices, which should be similar to the example
below.
■
hme
identifies the Sun FastEthernet PCI adapter’s Ethernet device
■
network
identifies the on-board Ethernet Device
Make a note of the Sun FastEthernet PCI adapter’s
hme
pathname for future
reference.
Note –
If these devices are not listed, check that the adapter is properly seated and
reinstall the adapter, if necessary.
ok show-nets
a) /pci@1f,4000/SUNW,hme@2,1
b) /pci@1f,4000/network@1,1
q) NO SELECTION
Enter Selection, q to quit: q
ok
