Sun Microsystems 817-4054-15, Руководство по обслуживанию

Страница: 91 / 204

Chapter 6 Storage Devices 6-5
4. Insert the disk drive into the bay as far as it will go.
5. Close the drive handle to connect the drive to the system.
6. Detach the antistatic wrist strap.
7. Close the front door of the system.
8. Reconfigure the disk drive, if necessary, by using DR.
Refer to the system administration manual.
9. Ensure that the OK to remove ( ) LED is no longer lit.
6.2 Removable Media Module
Caution –
Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in its packaging box before placing them on any surface.
Caution –
This procedure requires the system to be extended out of the system
cabinet on its slides. Also, before attempting this procedure, you must extend the
system cabinet stabilizer bar.
The removable media module is located at the front of the system (
FIGURE 6-5
). You
do not need to remove the removable media module in order to remove and replace
the tape drive and DVD-ROM drive. If the removable media module is defective,
you must replace it.