Sun Fire X4600, Руководство по установке

Страница: 47 / 66

About ILOM SP IP Addresses and the ILOM Interfaces
The ILOM SP is assigned a DHCP IP address by default.
There are two requirements for DHCP IP address assignment to occur:
■
Connection to your network must be through a NET MGT port.
■ DHCP services must be present on your network infrastructure.
If a DHCP server cannot be reached after three DHCP requests, the ILOM SP is assigned a static
IP address based on the network management port MAC address. This IP address is always in
the format 192.168.xxx.xxx, where xxx.xxx is the remainder of the IP address.
You can choose from one of several ILOM SP interfaces to support system management on
your server.
You can access SP firmware applications through the following ILOM SP interfaces:
■
Serial port command-line interface (CLI) (local access)
■
Secure shell (SSH) CLI (remote access over the network)
■
Web browser user interface (remote access over the network)
Determining the SP IP Address
You need to determine the service processor (SP) IP (network) address to use the SP Integrated
Lights Out Manager (ILOM) to manage the server.
You can determine the IP address through either one of these ways:
■
“How to Get the SP IP Address Using the BIOS Setup Utility” on page 47
■
“How to Get the SP IP Address By Using a Serial Connection and the CLI” on page 48
▼
How to Get the SP IP Address Using the BIOS Setup Utility
■
Complete the hardware setup as described in the hardware setup documentation.
■
Apply standby power for your server by plugging an AC cord into the system power supply.
See
“Server Connections” on page 45 for the location of the power cord connectors.
Reboot the server.
Press the F2 key when prompted, to access the BIOS Setup Utility.
In the BIOS Setup Utility, choose Advanced
→
IPMI 2.0 Configuration
→
Set LAN Configuration
→
IP address.
The IP address for the SP is displayed.
Before You Begin
1
2
3
Determining the SP IP Address
47