1109
TUCSON XL PATIO AWNING
14
14
Installation Manual
4.3 - Adjustment of Awning Inclination
INFORMATION AND PRECAUTIONS
The instructions that follow are of a general nature
and must therefore be adapted to the model of
awning being assembled.
For this procedure, one worker will need to work on
the brackets, and the other, only after opening the
awning, will guide the front bar so as to raise or lower
the awning easily.
WARNING
Make sure that when opening/closing the awning,
there are no individuals within its range of action
who are not involved in the work.
FIG. 11
A
B
7) Remove the shoulder covers from both sides of the
awning.
8) Loosen the 3 screws (A).
FIG. 12
tighten to decrease inclination
loose to increase inclination
9) Adjust the inclination of the awning using the
relevant Allen key on the screws (B - Fig.11).
Repeat for both arms.
FIG. 13
C
10)Using a level (C), check that the front bar is
horizontal. If not, adjust the support screw (B,
Fig. 11) for the arm that is not level, following the
procedure described above. Once the desired
inclination has been achieved, tighten the screws
(A - Fig. 11).
11)Refit the shoulder covers previously removed.
FIG. 14
12)Check that the elbows of the arms are parallel.
FIG.15
d
13)If not, open the awning slightly and tighten the
grub screw (D) to raise the elbow of the arm, and
unscrew to lower it.
14)Repeat the same steps for the other end of the
awning.
