Scenario 7 - Non T-Max® Remote System wired to unit
Most non-T-Max® remote systems control the sunbed by the use
of a relay. The relay operates the sunbed by connecting and dis-
connecting a pair of wires leading from the sunbed. Refer to the
user’s manual provided with your remote system to determine if
it operates in this way. To
connect your sunbed to this
type of system a remote
interface kit is required.
Contact your place of pur-
chase to obtain the kitt. The
illustration at right details a
typical connection. Follow
the instructions provided
with the kit and from the
remote’s manual to make
the necessary connections.
Go straight to the source with all your T-Max® brand remote
questions:
(417) 338-5101
Page 4 - 27356-02A
Scenario 3 - T-Max® Manager Series with Complete Wireless
Connect one AP-900 Retail to the Manager and one AP-900 OEM to
each of the tanning beds. Install as many beds as you like with this
configuration. Units that do not communicate with T-Max will need an
AP-900 Retail and an additional 3A to operate.
Scenario 4 - T-Max® Manager Series with Wireless combination
Connect one AP-900 Retail to the Manager and one AP-900 OEM to
a wireless ready tanning bed. The rest of the salon may be “daisy-
chained” together and connected to the wireless equipped tanning
bed, eliminating the need to wire the Manager to the tanning beds.
Scenario 5 - T-Max® Manager Series with Wireless combination 2
Wireless can be easily added to an existing salon already utilizing T-
Max®. Connect one AP-900 Retail to the Manager and one AP-900
OEM to each wireless ready tanning bed. The
rest of the salon may be “daisy-chained”
together and connected to the Manager.
Scenario 6 - T-Max 3A with Wireless
Connect one AP-900 Retail to the T-Max® 3A and one AP-900 OEM
to the tanning bed in single bed installations.
Setting the address manually
Before connecting your sunbed to the T-Max® Manager or T-Max® 1A
or 3A, the address of your sunbed must first be set. Set the address man-
ually as described below.
Setting the Address
1.
Make sure the sunbed display is showing “0”.
2.
Press the red stop button and, without releasing it, press the
green timer button and hold both for three seconds. The display
should indicate an address number from “1” to “255”.
3.
If you are using a T-Max® 1A or 3A as a “master” remote, the
address of the sunbed must be set to “1”. If you are using a T-
Max® Manager each sunbed must be assigned a different
address. To adjust the address, press the green timer button to
count up until the desired number (from 1 to 128) is achieved.
Addresses 252 to 255 are not normally used.
4.
Press the red stop button to return to the normal display mode.
1-99
100-128
(blinking dot)
252-255
(blinking dot)
