Sumo SMK36GEN, Инструкция по безопасности и эксплуатации

Страница: 13 / 20

1100w PORTABLE GENERATOR SMK36GEN
Hold down the generator firmly with one hand on the
frame.With the other hand grip the recoil starter cord
handle (See Fig 7) and pull slowly until resistance is felt
indicating that the recoil starter is engaged.When
resistance is felt pull the cord sharply. Continue this
procedure until the engine starts.
When the engine has been successfully started and is
running smoothly return the choke lever to the RUN
position.
Warning! Before connecting any electrical load to the
generator ensure that the load does not exceed the
maximum load as stated on the rating plate. Ensure that
the mains supply lead is long enough to reach the
generator without any strain.
When the generator engine has been successfully
started and is running smoothly connect the electrical
load into the generator AC output socket.
5. STOPPING THE GENERATOR ENGINE
Before stopping the engine make sure that all the
electrical loads are disconnected from the generator AC
outlet sockets.Turn the generator ON/OFF switch to
the OFF position.
When the generator engine has stopped and before
storage, turn the fuel tap lever to the OFF position.
6. OVER LOAD PROTECTION
The generator is fitted with 2 overload protection
devices located on the control panel. In the event that
the load exceeds that stated on the rating plate, the
overload protection will operate and disconnect the
load. If the overload protection device is tripped Check
the electrical load and if necessary reduce the load.The
d.c. overload protection device can be re-set by
pressing in the re-set button (See Fig 8).The a.c.
overload protection device can be re-set by pressing in
the re-set button (See Fig 9).
Fig 8
Fig 9
Fig 7