Sumner GH5T, Руководство оператора

Страница: 6 / 10

6
2. Assemble Components
1. Lay out cross beam in a cleared area. Position
one A-Frame at either end of the cross beam as
shown.
2. Lift one side of cross beam onto A-frame saddle
and line up outside bolt hole on A-frame with the
outer most bolt hole on cross beam. Place bolt
through bolt hole on A-frame and cross beam
with washers on either side of the bolt. Loosely
tighten so A-frame/Cross Beam joint can swivel
when A-frame is erected.
3. Place trolley onto the opposite end of the cross
beam. Center trolley on cross beam and tighten
with set screws.
4. Lift opposite cross beam end and position onto
second A-frame saddle lining up outside bolt
hole on A-frame with outer most bolt hole on
cross beam.
5. Place bolt through bolt hole on A-frame and cross
beam with washers on either side of the bolt.
Loosely tighten so A-frame/Cross Beam joint can
swivel when A-frame is erected.
6. The supplied Chain Set and Hoist will be required
to erect the A-Frames.
7. Attach the end most hooks on the Chain Sets to
the eyelets on each A-Frame.
8. Attach the Hoist to the Spreader Plates on each
Chain Set.