Summit SWC1987T, Руководство пользователя

Страница: 8 / 16

7
NOTE: All parts removed must be saved to allow the door swing to be reversed.
1. Carefully use a sharp tool to pry up the decorative cap at the top of the cabinet
and also the cap of the door hinge (Fig.1).
2. Open the door slightly, remove the screw holding the door hinge cover, remove
the upper door hinge cover, then unscrew all the screws holding the upper door
hinge. Be sure to hold the glass door firmly while removing the screws and
taking off the door (Fig. 2).
3. Remove the screw of the right lower door hinge and the left side screw of the
front vent (Fig. 3). Then take the left lower door hinge from the plastic bag
containing the manual andinstall it at the designated position on the opposite
side (Fig. 4).
4. Remove the screw holding the door handle, then remove the bottom screw at
the left side of the door and remove the lower support of the door (Fig. 5). Install
the lower support of the door on the opposite side (Fig.6).
5. Pull open the middle section of the door gasket to reveal the handle screw hole
(Fig. 7). Remove the handle and install it on the opposite side(Fig. 8).
6. Install the upper door hinge on the opposite side and tighten the screws (Fig. 9).
7. Set the lower door shaft into the shaft hole of the lower door hinge (Fig. 10), and
then do likewise with the upper door shaft and shaft hole (Fig. 11). Adjust the
door so that it is aligned with the cabinet and level, then tighten all lock screws.
If necessary, you can call customer service for door reversal instructions.