6
•
WARNING
: Do not store or install the appliance outdoors.
•
CAUTION
:
This appliance is designed for storing and cooling wines. Do not store perishable food,
medicine or other medical products.
•
Place your Wine Cellar on a floor that is strong enough to support it when it is fully loaded. To level the
unit, adjust the front leveling legs.
•
For free-standing installation, leave 5 inches (127mm) of space around the back and sides of the unit
to allow proper air circulation to cool the compressor and condenser. Even for built-in installation, you
should provide the following clearances to ensure the best operation and proper ventilation: 3/16” on
both sides, 2” at the rear and 1/16” at the top. Take care that the air vent at the front of the appliance is
never covered or blocked in any way.
•
NOTE: It is recommended that you do not install the appliance near an oven, radiator or other heating
source. Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Don’t install in a location where the temperature will fall below 60°F (16°C). For best
performance, do not install the appliance behind a cabinet door or block the base grille.
•
Avoid locating the unit in moist areas.
•
Plug the Wine Cellar into an exclusive, properly grounded wall outlet. Do not under any circum-
stances cut or remove the third (ground) prong from the power cord. Any questions concerning power
and/or grounding should be directed toward a certified electrician or an authorized service center.
BUILT-IN CABINET INSTRUCTIONS
This unit is designed for either built-in or free-standing installation. If you plan to use the unit in a built-in
application, use the following dimensions for the enclosure:
Model
SWC1875
Width
23
⅝
” / 60 cm
Depth
23
¼
” / 59 cm
Height
63
¾ " / 162 cm
ELECTRICAL CONNECTION
This appliance should be properly grounded for your safety. The power cord of this appliance is equipped
with a three-prong plug which mates with standard three-prong wall outlets to minimize the possibility of
electrical shock.
Do not under any circumstances cut or remove the third (ground) prong from the power cord supplied. For
personal safety, this appliance must be properly grounded.
This appliance requires a standard 115/120 Volt AC ~ 60Hz three-prong grounded electrical outlet. Have
the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.
When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
To prevent accidental injury, the cord should be secured behind the appliance and not left exposed or
dangling.
WARNING
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by a qualified electrician or an authorized service center.
