PG 9
5
SETUP AND USE
PLATFORM RATCHET STRAP
1.
Attach the Ratchet with Loop End to the
yoke tube
at location
A
as shown in
figure 35
. Put the sewn loop around the tube (
figure 36
)
and then push the ratchet through the loop (
figure 37
) to create a
cinch knot as shown in
figure 38.
2.
Attach the Short Strap for the Ratchet to the opposite
yoke tubing
at location
B
shown in
figure 35
. Loop the free end of the strap
around the tube and then through the sewn loop. Pull to create a
cinch knot. This is the platform tie down ratchet strap.
LADDER STABILIZER STRAPS (CAM BUCKLE)
1.
Attach the two Long Stabilizer Straps to the
yoke tube
at locations
A and B in figure 35.
Use the same procedure from
Step 1
above
to create a cinch knot for each strap. These are the two main ladder
stabilizer straps.
2.
Attach the Cam Buckle end of each strap
to the bottom ladder
column
between the second and third rungs as shown in
figure 39
.
Use the same procedure to create a cinch knot.
3.
Before setup, run the Long Stabilizer straps to the Cam Buckles and
thread the free end of the strap through the cam buckle as shown in
figure 40.
Pull the free end on both straps until they are tight.
These two straps provide support to the ladder column while you are
setting your stand up and double as Stabilizer straps once the stand is
in place.
35
A
B
36
37
38
WARNING
!
Never Wrap The Stabilization Straps Around The
Ladder Rungs! Wrap Them Only Around The Ladder
Columns! (
see figure 39
)
40
39
