Summit Pool Heat Pump, Руководство пользователя

Страница: 8 / 24

OWNER’S MANUAL
Installation Instructions
Location
The placement of the pool heater is very important in keeping installation
costs to a minimum while providing for maximum efficiency of operation, as
well as allowing adequate access for service and maintenance.
The SUMMIT pool heat pump is designed for outdoor installation and
should not be installed in a fully enclosed area, such as a shed, garage, etc.,
Recirculation of cold discharged air back into the evaporator coil will greatly
reduce unit heating capacity and efficiency.
The unit should be located as close as practical to the existing pool pump and
filter to minimize water piping. However, do not forget to provide a 24” clear-
ance at the very least all around your heat pump. The use of 90 degree bends
and short radius elbows in the water piping should be kept to a minimum.
Mount the unit on a sturdy base, preferably a concrete slab or a set of blocks.
The base should be completely isolated from the building foundation wall to
prevent the possibility of sound or vibration transmission into the building.
The size of the base should not be less than 36” x 36” (92 cm x 92 cm).
All SUMMIT pool heat pump models feature ultra-
silent ventilation systems. Air is pulled through the
evaporator coil and discharged through the top
grille. A minimum clearance of 48 inches should be
allowed above the unit for unrestricted air discharge.
The unit must not be installed under a porch. Any
side of the unit should be located at least 24 inches
from a wall or from any other obstruction for unre-
stricted air intake and service access.
IMPORTANT
?
48”
24”
24”
24”
6