13
Aligning the Top Line of your Rear Wall Template
CAUTION: Wear gloves when installing to prevent cutting your fingers on sharp edges.
1. Using a tape measure, draw a vertical line
on the wall at the center of the 24” wide space.
2. Tape the rear wall template on the wall, aligning the center marks on the rear wall template with
the center line on the cabinet.
3. The location of the rear wall template will depend on what type of cabinet you are installing the
microwave under. (See above examples.)
4. After taping the rear wall template to the wall, draw circles at the A, B, and C holes (see above
illustration).
NOTE:
You must use all three mounting holes. It is recommended to use four mounting holes if
there are 2 wall studs on the left and 2 wall studs on the right of the center line.
5. Remove the rear wall template, and check the markings based on the actual mounting plate
(centerline, hole A, B, and C).
6. Drill holes on the circle marks fo
r A, B, and C. Use a 3/16” bit for hole C (to mount into the
wooden stud)
and a 5/8” bit for A and B (to secure with a toggle bolt).
NOTE:
Do not mount the plate yet.
7.
If the rear wall template is
damaged or unusable, measure
and mark the wall with the
dimensions shown to the right:
Содержание MHOTR241W
Страница 11: ...11 Framed Recessed Cabinet...
