Summit FF41ES, Инструкция по эксплуатации

Страница: 6 / 14

INSTALLATION
To use the refrigerator with the most efficiency and safety, select a suitable place to
install it according to the following guidelines:
1. This refrigerator is designed for free-standing installation only and should not be
recessed or built in.
2. The refrigerator should be installed on a sturdy, level floor or counter. If the floor
is not quite level, adjust the front feet of the unit.
3. Allow 4 inches of space between the back of the refrigerator and the wall behind.
4. Avoid any direct sunlight, heat or moisture.
5. The refrigerator is equipped with a three-prong plug and is grounded to minimize
electrical hazards. To make it effective, the refrigerator must be plugged into a
grounded electrical socket.
6. Do not use an extension cord.
Test Run
Before using the refrigerator, clean it and make a test run to see if it follows the behavior
described here. If not, check the electricity supply. If the cause of the trouble cannot be
located, contact your Summit dealer.
1. Set the Temperature Control Knob at the OFF position and then plug the power
cord into an electrical outlet of 115 volts, 60Hz. The compressor should not run.
2. Set the Temperature Control Knob at the MAX position and let the refrigerator
operate for 20 minutes. The freezer compartment should get slightly frosted and
the compressor should run smoothly with no noise but a soft hum.
3. Then rotate the Temperature Control Knob counter-clockwise toward the MIN
position. Before the pointer of the knob reaches MIN , the compressor should turn
off.
ATTENTION
Your refrigerator is equipped with a special thermostat control
device. If the unit is turned off or unplugged, YOU MUST
ALLOW THREE (3) MINUTES BEFORE RESTARTING OR
REPLUGGING THE UNIT.
The unit will not start if you attempt to restart it in less than
three (3) minutes.
5