background image

4

 

 

 

In the event of any damage: 

 

Avoid open flames and anything that creates a spark, 

 

Disconnect from the power source, 

 

Air the room in which the appliance is located for several minutes, and 

 

Contact the Service Department for advice. 

  The more coolant there is in an  appliance, the larger the room in which it should be installed. In the 

event of a leakage, if the appliance is in a small room, there is the danger of combustible gases building 
up. For every ounce of coolant, at least 325 cubic feet of room space is required. The amount of coolant 
in the appliance is stated on the data plate inside the appliance. It is hazardous for anyone other than 
an Authorized Service Person to carry out servicing or repairs to this appliance.  

  Take  serious  care  when  handling,  moving,  and  using  the  appliance  to  avoid  either  damaging  the 

refrigerant tubing or increasing the risk of a leak. 

  Replacing component parts and servicing shall be done by factory-authorized service personnel so as 

to minimize the risk of possible ignition due to incorrect parts or improper service. 

 
 
 
 

FOLLOW WARNING CALLOUTS BELOW ONLY WHEN APPLICABLE TO YOUR MODEL 

 

Use two or more people to move and install appliance. Failure to do so can result in back or other 
injury. 

 

To ensure proper ventilation for your appliance, the front of the unit must be completely unobstructed. 
Choose a well-ventilated area with temperatures above 44°F (7°C) and below 100°F (38°C). 

 

The appliance should not be located next to ovens, grills or other sources of high heat. 

 

The appliance must be installed with all electrical, water and drain connections in accordance with 
state and local codes. A standard electrical supply (115 V AC only, 60 Hz), properly grounded in 
accordance with the National Electrical Code and local codes and ordinances, is required. 

 

Do not kink or pinch the power supply cord of the appliance. 

 

The size of the fuse (or circuit breaker) should be 15 amperes. 

 

It is important that the appliance be leveled in order to work properly. You may need to make several 
adjustments to level it. 

 

All installations must be in accordance with local plumbing code requirements. 

 

Make certain that the pipes are not pinched, kinked or damaged during installation. 

 

Check for leaks after connection. 

 

Never allow children to operate, play with or crawl inside the appliance. 

 

 

Do not use solvent-based cleaning agents or abrasives on the interior. These cleaners may damage 
or discolor the interior. 

 

Use this appliance only for its intended purpose as described in this 

Instruction Manual

 

Keep fingers out of the “pinch point” areas. Clearance

s between the drawers and cabinet are 

necessarily small. Be careful closing drawers when children are in the area. 

 
 

                                  Risk of child entrapment! 

 

Child entrapment and suffocation are not problems of the past. Junked or abandoned appliances are 

still dangerous, even if they will “just sit 

for 

a few days”.

 

Before discarding your old appliance: 

 

Take off the doors 

 

Leave the shelves in place so that children may not easily climb inside. 

 
 

- SAVE THESE INSTRUCTIONS - 

 

Содержание FF12DROS24

















Отзывы: