Summit Accucold AL752BK, Инструкция по эксплуатации

Страница: 9 / 16

9
To prevent accidental injury, the cord should be secured behind the unit and not left exposed or
dangling.
The unit should always be plugged into its own individual electrical outlet which has a voltage
rating that matches the rating label on the appliance. This provides the best performance and
also prevents overloading house wiring circuits that could cause a fire hazard from overheated
wires. Never unplug the unit by pulling on the power cord. Always grip the plug firmly and pull
straight out from the receptacle. Repair or replace immediately any power cord that has become
frayed or otherwise damaged. Do not use a cord that shows cracks or abrasion damage along
its length or at either end. When moving the unit, be careful not to damage the power cord.
Extension Cord:
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified
electrician or service technician install an outlet near the appliance.
Reversing the Door Swing:
If you find the direction of opening the door of the appliance inconvenient, you can change it.
Holes on the opposite side have already been prepared at the factory.
This appliance can be opened from either the right side or the left. By default, the door hinge is
on the right side. If you prefer it on the left, please follow the appropriate instructions:
For models FF6BK, FF7W, FF7WCOM, FF7BK and FF7BKCOM:
1. Take off the upper hinge cover from the door and remove the screws that hold the top hinge.
2. Lift the hinge straight up to free the hinge pin from the socket in the top of the door.
3. Lift the door up and away to free its bottom socket from the hinge pin.
4. Remove the screws to the bottom hinge.
5. Remove the decorative caps from the opposite side and plug the holes from the original side
with the decorative caps.
6. Move the bottom hinge to the opposite side and tighten the screws. Use any lock washers or
nuts if they were installed in the original installation.
7. Replace door onto the hinge pin on the bottom hinge. Place top hinge pin into door. Insert
screws into the top hinge and tighten.
If you notice the door not hanging straight, loosen the top hinge screws, adjust the door until it is
level and tighten the screws.