PG 5
PUTTING ON THE HARNESS (continued)
4.
Adjust belt strap by pulling on tag end (
figure
7
) until comfortably snug. Roll the free ends of the
webbing up and use the hook and loop straps to secure
as shown in
figure 8
.
5.
For the
STS Pro
, rotate the pouch to your front.
Unsnap the pouch and pull out the black tether strap
(this strap will act as a pull cord to pull out the shoulder
straps). Once the straps are out, rotate the pouch back
behind you. Slip your arms through the shoulder straps
as you would a jacket. Be sure the shoulder straps do
not cross each other and that they are not twisted.
6.
For
All STS models
adjust the 3-bar slide on each
shoulder strap (
figure 9)
until the shoulder straps and
waist belt are comfortably snug as shown in
figure 10
.
7.
The adjustable, rubber coated 3 bar slide on the end
of each leg strap controls the overall length of your
leg straps. (
See figure 11
) Slide this 3 bar slide up
or down the webbing and then pull the slack through
the rubber coated buckle as shown in
figure 12
. Roll
the free ends of the webbing up and use the hook and
loop straps to secure.
8.
For
All STS models
, bring leg strap BEHIND the leg
then between the legs to the front as shown in
figure
13
.
9.
Thread the male part of the leg buckles through the
female part as show in
figure 14
. If the leg straps are
loose pull on the free end of the webbing until snug.
Leg straps should be comfortably snug (
see figure 15
).
You should only have to adjust the strap length once as
you initially fit the harness.
10.
Fasten the chest buckle next as shown in
figure 16.
3 BAR
SLIDE
9
8
16
10
11
12
13
14
15
