SUMMIT APPLIANCE Page 5
appliance straight out when moving it. Do not wiggle or “walk”
the appliance when trying to move it, because floor damage
can occur.
5. Clean Before Using:
After you remove all of the packaging materials, clean the in-
side of your appliance before using it. See cleaning instruc-
tions in the
Cleaning and Maintenance
section of this manual.
6. The appliance has leveling legs at the front. For best opera-
tion, be sure the unit is level.
Keep flammable materials and vapors such as gasoline away from
appliances. Failure to do so can result in fire or explosion.
LOCATION REQUIREMENTS
IMPORTANT: Do not install the appliance near an oven, radiator
or other heat source, nor in a location where the temperature will
fall below 45°F (7°C). Do not place in direct sunlight.
Check the strength of the floor before installing the appliance. It
should hold the weight of a fully loaded appliance. Allow at least
1” (2.5 cm) of airspace at the top and on both sides of the appli-
ance and 1” (2.5 cm) between the back of the appliance and the
wall. If the appliance is going to be placed beside a wall, if possi-
ble, leave extra space on the hinge side so the door can open
wider than its width (to make it easier to remove shelves or stor-
age bins.)
Choosing the Right Place
Place the unit in a dry and regularly ventilated place. It is recom-
mended that this appliance always be operated in an ambient tem-
perature of at least 32°F and under 90°F. The appliance may be
exposed to lower or higher temperatures but only for a short
period of time. Never place the appliance near heat-emitting
devices (e.g., oven, radiator, water heater or similar devices) or in
moist areas, and do not expose it to direct sunlight..
Recommended Grounding Method
A 115V, 60Hz AC-only, grounded electrical supply, including a 15-
or 20-amp fuse or circuit breaker, is required. It is recommended
that a separate circuit serving only your appliance be provided.
Use outlets that cannot be turned off by a switch or pull chain.
Connect this appliance to a 3-prong power supply socket (which
has a good ground terminal). If you only have a two-prong outlet,
have it replaced by a qualified electrician with an outlet that meets
