Electrical Connections:
(This EQP-200B is wired as a pin 2 hot device. Units made before March 1
st,
2003 come
factory wired with pin 3 hot.)
Input:
Unbalanced: 3 pin XLR Connector
Balanced:
3 pin XLR Connector
Pin 1 – Ground
Pin 1 – Ground
Pin 2 – (+) Signal
Pin 2 – (+) Signal
Pin 3 – Connect to Pin 1
Pin 3 – (-) Signal
Output:
Unbalanced: 3 pin XLR Connector
Balanced:
3 pin XLR Connector
Pin 1 – Ground
Pin 1 – Ground
Pin 2 – (+) Signal
Pin 2 – (+) Signal
Pin 3 – Connect to Pin 1
Pin 3 – (-) Signal
Note: When running an unbalanced output it is best to connect pin 3 to pin 1 in the
connector that plugs into the EQP-200B.
Allow the EQP-200B to warm up for at least 15 minutes before using it in your
processing chain. The tubes and other circuitry need time to reach an electronic
equilibrium before they will operate at optimal specifications. For the longest life, it is
recommended that you turn off the unit when it is not in use.
Please mount the unit in your rack, making sure that there is sufficient ventilation,
especially on the right and left side of the chassis. The EQP-200B will generate a
significant amount of heat; therefore, it is necessary to have good air flow to prevent
damage to your EQP-200B or any other pieces of gear housed in the rack with it.
The tubes in your Summit Audio EQP-200B have been intensely screened for
desired distortion and gain characteristics. We recommend that you do not replace the
tubes with “guitar amp” tubes. Please consult your dealer about availability of
appropriate replacement tubes. These can also be ordered directly from Summit Audio.
Please fill out the enclosed warranty card. If you have any questions about the operation
of your EQP-200B, please do not hesitate to call our customer service department at 775-
782-8838 or contact us on the internet at: [email protected].
SPECIFICATIONS
Содержание EQP-200B
Страница 4: ...1 3 5 7 9 2 6 4 8 10...
