No picture or sound on Monitor
• Make sure the Monitor is turned on
• Make sure the AC Adapters are plugged in
• Make sure the outlets are working
• Make sure Monitor and Camera are SYNCHED up.
Sound but no picture on Monitor
• Press the Video On/Off Button once to turn on video mode
• Try adjusting the Brightness Control on the Monitor
• Test reception by moving the Monitor and/or CAMERA to
different locations
Picture but no sound
• Turn up the volume on the Monitor using the Volume
Control
Picture not clear
• Position the Monitor closer to the CAMERA if necessary
• Move Monitor away from other monitors, cordless
phones, walkie-talkies, etc.
• Try adjusting the Brightness Control on the Monitor
• Test reception by moving the Monitor and/or CAMERA to
different locations
Squealing sound
• Move the CAMERA and the Monitor further away from
each other
Step 1:
Delete your camera by tapping the
control panel to activate. Press menu “ ”
button to enter the camera menu. Press “ ”
to highlight “del cam”.
Step 2:
Press “ ” to confirm selection.
Step 3:
When camera has been sucessfully
deleted, the Summer logo will appear with a
“no signal” message.
To Resync Camera:
To Delete Camera:
To Resync Gateway:
The Monitor and Camera are synched at the
factory for privacy reasons. If the Monitor and
Camera are not synching with each other for any
reason, please sync them as described below.
problem solving/troubleshooting for monitor:
deleting and resyncing camera:
Make sure you meet system requirements
• At the installation location of your gateway, you need a
broadband Internet connection (cable/DSL) with
recommended upload speed of 300 bps and a wireless router
and or a cable/DSL modem with an available ethernet/LAN
port to properly access and view your cameras, you must
have a required browser version Internet Explorer 7.0 or
higher, Mozilla Firefox 3.0 or higher, Safari 4.0 or higher, or
Google Chrome. Make sure you have the latest version of
Adobe Flash Player which you can download at:
http://www.adobe.com/support/flashplayer/downloads.html
Gateway is not connecting to the internet
• Make sure that your gateway Ethernet cable is plugged into
the LAN port of your router and confirm that the green internet
light on the front of the gateway is blinking. The power light
should be green to show that your gateway is powered on
and successfully synced with your camera. If the power light is
red, this indicates that your gateway is no longer synced with
your camera. Refer to synching monitor and gateway section
below.
problem solving/troubleshooting for gateway:
nonresponsive gateway resyncing:
Step 1:
Move the Monitor to the same area
as the Camera. Make sure that both the
Camera and Monitor are powerd on.
Step 2:
To add a camera, tap the control
panel to activate. Press the “menu ”
button to enter the camera menu. Press “ ” again to select “Add
Cam”. Power LED will begin to blink rapidly.
Step 3:
Press the code button on back of Camera to synch (see
illustration).
Step 4:
Once synched, a picture from the newly added Camera will
appear on Monitor screen. Camera’s power LED will stop blinking.
Step 1:
Move the Monitor to
the same area as the
Gateway. Make sure that
both the Gateway and
Monitor are powerd on.
Step 2:
Press the code button
on back of gateway to synch
(Figure A).
Step 3:
Once synched
successfully, synced power
LED on gateway will turn
green (Figure B)
The Camera and Gateway
are synched at the factory for
privacy reasons. If the
Camera and Gateway are
not synching with each other
for any reason, please sync
them as described below.
A
B