3
SET UP:
M
N
O
H
Headboar
d
Footboar
d
Bedrail Panel
At Least 9“
At Least 9“
2
FEATURES & COMPONENTS:
SET UP:
Step 1:
Insert top, middle and bottom connector
tubes into each end rail (Figure A).
Note:
Top and bottom connector tubes
have pins on each side, and the pins snap
into end rails. Middle connector tube does
not have pins.
Step 2:
Insert support leg into end of bedrail
frame and snap into place (Figures B & C).
Take second support leg and repeat on
other side.
Step 3:
Fold down support legs as shown in
Figure D, until spring lock is engaged
(see Figure E).
Step 4:
Place fabric panel completely over bedrail
frame and slide down (Figure F).
Note:
Assure that bottom rail is covered by
fabric panel.
Step 5:
Zipper bottom of fabric cover over bottom
rail to fasten. Attach hook & loop flap to
cover opening.
Step 6:
This bedrail fits twin, full and queen size
mattresses. Connect mattress anchors to
3-way connector on both sides by snapping
mattress anchor into place
(Figure H).
Note:
Be sure to orient
the mattress anchor
with notch facing down
(Figure G).
A
B
C
F
Lock
engaged
Lock
pin
D
E
press
button
Step 7:
Attach strap clip to 3-way connector (with notch facing down)
(Figure I).
Step 8:
Remove mattress from bed.
Step 9:
Position assembled bedrail on boxspring. While holding the
release lever on bottom corner of bedrail, pull the strap to
proper tension until snug against boxspring (Figure J).
Repeat on the other end of the bedrail.
Step 10:
Place mattress back on box spring. Pull the strap to proper
tension until tight against mattress (Figure J).
NOTE:
Press release lever down when strap is tight to lock
strap in place (Figure K). Roll up excess strap and tuck under
mattress (Figure L).
Step 11:
Ensure the bedrail is centered on the mattress end to end.
Using enclosed template, measure AT LEAST 9 inches
between the ends of the bedrail and the headboard and
footboard (Diagram M).
TO CONNECT 2 SINGLE BEDRAILS
TO CREATE A DOUBLE BEDRAIL
Step 1:
Remove 3-way connector from mattress anchor
by pressing button with a pen or screwdriver (Figure N).
Step 2:
Rotate 3-way connector and connect
2 single bedrails under mattress
(Figure O).
Step 3:
Follow steps 7 through 8 to finalize
installation of double bedrail.
Bedrail Frame
(3 connector tubes
& 2 end panels)
:
Fabric Panel:
Fold-down
Support
Leg
(two)
:
Mattress
Anchor
(two)
:
3-way
Connector
(two)
:
9“ Template:
9
8
7
6
5
4
3
2
1
J
Release Lever
L
K
Tuck excess strap
under mattress
I
G
Mattress
side
Box spring
side
no pins
pins
pins
Mattress
