Document: SP F04 052
Date Issued: 09/20
Revision
: 1
5.0 Installation of 2 RU in Rack
5.1 First, take off the front cover. See
Figure 3
.
Figure 3: Slide front cover
sideways to remove from panel
unit pins.
5
5.2 Pull out tray by pulling up on pin as you
slide it out shown in
Figure 4
. Separate the
three parts of the panel shown in
Figure 5
.
Figure 6: 3 Screws fastened into rack
mounting bracket.
Figure 7: Use the 4 largest screws for
tightening panel into rack.
Figure 4: Pull out inside tray.
Figure 5:Panel (Left), Insert (Lower Right),
and Cover(Upper Right) disassembled.
5.4 Install rack mounting brackets on side of
panel as shown in
Figure 6
.
5.5 Mount into rack using brackets. See
Figure
7.
Keep insert outside so you can place cable
management tools.
6.0 Cable Management Spools and Splice
Tray Holder Installation
6.1 Install cable management spools in the
insert portion as shown in
Figure 8.
Cable
management spools installed in any position
based on user preference
. Figure 8
shows a
configuration that will fit a splice tray in the
middle of them.
