Sumitomo Drive Technologies VP2500L, Руководство пользователя

Страница: 24 / 36

Commissioning
Use the device - general instructions
• The device must be stable and easy to access.
• The connecting gear unit or the hydraulic system must be stopped when you start the
device.
• Always turn off the device before you do a check on the oil level in the gear unit or the
hydraulic system.
• Do a check on the oil level in the gear unit or the hydraulic system before the test run
of the device.
• Do a check for leakages and do a check on the oil level before you start the gear unit
or the hydraulic system again.
Commissioning
Procedure
1. Start the device. Refer to section
Start the device
on page 25.
• Make sure that the oil flows through the device and into the gear unit or the
hydraulic system.
Caution: If the oil does not flow through the device and into the
gear unit or the hydraulic system within one minute, stop the device
immediately. Speak to S.D.T.
• Let the device run for some minutes.
2. Stop the device. Refer to section
Stop the device
on page 25.
3. Do a check on the oil level in the gear unit or the hydraulic system.
The commissioning is completed.
7
7.1
7.2
Commissioning
24
UM_VP2500L_002_EN